2016-2019 Bikes

How to swap bottom bracket torque sensor on your 2018/2019 Rook and Colt

Surface 604 bottom bracket torque sensor installation steps and tips

This video covers the basic steps. https://www.youtube.com/watch?v=KviaJ_Cqt6I 1. Install the non drive side cup until it's fully tight. Set the inner bearing flush with the end of the cup. You’ll tighten that up last. Add some grease to the bearing

My headlight lights up when I press the brakes

If your headlight is lighting up when you press on the brakes, it is likely that the headlight is wired to the tail light and vice versa. To resolve this, you will need to switch the two connections which are illustrated in image 1 below. Image 1: Re

[Rook / Colt] My pedal assist is intermittent

Your pedal assist may be intermittent after changing a flat. The reasoning behind this is that there is a specific washer layout that you need to have on your rear axle in order for the torque sensor to output the correct signal to the controller and

[Boar E350] My pedal assist is intermittent

Your pedal assist may be intermittent after changing a flat. The reasoning behind this is that there is a specific washer layout that you need to have on your rear axle in order for the torque sensor to output the correct signal to the controller and

How to assemble 2018/2019 Rook and Colt

How to assemble 2018/2019 Boar Hunter

2018/2019 PAS troubleshoot

If your pedal assist is erratic or not working at all, your motor inhibitors could be preventing the system from running smoothly. If your throttle works fine, then these steps are sure to help. First, identify the motor inhibitors (orange circle).Us